© 2024 Jasper van Baten, AmsterCHEM

Product stream

Connecting the product stream to the XFlowSaver unit operation is optional.

If the product stream is connected, it will be set equal to the feed stream. For this, at least the properties "Flow Rate" and "Composition" or the property "Compound Flow Rate" must be present in the property configuration.

The product stream will be flashed using the recommended auto-flash method. The properties required for this flash must also be present in the property configuration.

For the TP flash, "Pressure" and "Temperature" must be part of the property configuration. For the P-VF flash, "Pressure" and "Vapor Fraction" for the overall phase or "Phase Fraction" for each phase must be present. For the PH flash, "Pressure" must be present and the Write Enthalpy option must be checked in the XFlow file options.

INDEX
.xflow
.xflowloader
.xflowsaver
32-bits
64-bits
Advanced options
Auto flash
COM registration
Command line options
Comments in XFlow file
Compound mapping
Configuration file
Copy flow to clipboard
Copyright
Current flow data
Energy reference state
Feed stream
FlowExchange
Introduction
Last saved flow data
License
Load configuration
Phase information in XFlow file
Product stream
Property configuration file
Property selection
RegisterFlowExchange
Requirements for XFlow file content
Save configuration
Stand-alone viewer
Viewer
x64
x86
XFlow file association
XFlow file location
XFlow files
XFlow save options
XFlow viewer
XFlowLoader
XFlowSaver
CONTENT
 FlowExchange
 XFlow files
 COM registration
 XFlowSaver
 XFlow file location
 Specify properties
 Advanced options
 Current flow data
 Product stream
 Save and load configuration
 XFlowLoader
 Stand-alone XFlow viewer
 Property configuration file
 License